By submitting an RMA Request I agree to Kanomax USA’s published calibration prices. I understand that Kanomax USA is not an accredited lab, but is traceable to NIST.
Links To Other Web Sites
Our Service may contain links to third-party web sites or services that are not owned or controlled by Kanomax USA, Inc. Kanomax USA, Inc. has no control over, and assumes no responsibility for, the content, privacy policies, or practices of any third party web sites or services. You further acknowledge and agree that Kanomax USA, Inc. shall not be responsible or liable, directly or indirectly, for any damage or loss caused or alleged to be caused by or in connection with use of or reliance on any such content, goods or services available on or through any such web sites or services. We strongly advise you to read the terms and conditions and privacy policies of any third-party web sites or services that you visit.
These Terms shall be governed and construed in accordance with the laws of the State of New Jersey, without regard to its conflict of law provisions. Venue, if laid, shall be in Superior Court of the State of New Jersey. Our failure to enforce any right or provision of these Terms will not be considered a waiver of those rights. If any provision of these Terms is held to be invalid or unenforceable by a court, the remaining provisions of these Terms will remain in effect. These Terms constitute the entire agreement between us regarding our Service, and supersede and replace any prior agreements we might have between us regarding the Service.
We reserve the right, at our sole discretion, to modify or replace these Terms at any time. We will notify you of any changes by posting the new Terms on the site. What constitutes a material change will be determined at our sole discretion. By continuing to access or use our Service after those revisions become effective, you agree to be bound by the revised terms. If you do not agree to the new terms, please stop using the Service.
If you have any questions about these Terms, please contact us.